|
|
 |
|
|
|
Kobe
(SKU: INVKT-S0002-KOBEX-00001)
Basic Price (per unit): $4.35 (All prices in U.S. Dollars)
Minimum Order Quantity: 30
|
|
Additional product views:
|
|
|
|
|
 |
What you get in this kit (before customizations) |
 |
- Pocketfolder as shown with pre-assembled inside panel (four-corner ribbon layout) - available in your choice of paper and ribbon colors
- Ribbon: 3/8 inch width in your choice of color
- Printable Paper: 8 ½ x 11 cardstock (2 pieces)
- Front Square backing: 2 ¾ (height) x 2 ¾ (width) inches
- Response card backing: 3 ½ (height) x 4 ½ (width) inches
- Japanese paper band: 2 (height) x 12 (width) inches
- Envelope for response card
- Envelope for invitation (unlined)
|
Available Customization Options |
|
Folder Size, Folder Paper, Backing Paper, Inside Panel, Printable Paper, Ribbon Color, Pattern, Envelope
|
Instructions on this Product |
|
1) Use your favorite computer program to lay out your printed content on two 8 ½ x 11" pages, according to the following sizes:
- Monogram square for cover: 2 ½ (height) x 2 ½ (width) inches
- Invitation main layout: 4 ¾ x 4 ¾ inches
- Response card: 3 ¼ (height) x 4 ¼ (width) inches
(Refer to the sample print template provided in your package for an example.) Remember that sample layouts, wording, and monogram designs are available in the Bride's Guides section of our site.
2) Print and cut the printed parts of your invitations on the 8 ½ x 11 "Printable Paper" sheets provided in the kit.
3) Take the Main Layout you have printed and on the inside of the pocketfolder on the main panel slip this inside the corner ribbons covering the blank panel underneath.
4) Glue the Response card you have printed to the Response Card Backing provided and place in the pocket of th pocketfolder with stamped response envelope.
5) Close up the invitation. Take the Japanese paper/band provided in the kit and wrap around the middle of the closed invitation gluing one end of the band to the other so the band is tight around the closed invitation. Move the band so the point where the two ends meet ends up on the right side of the invitation about 1 ¾ inches from the right side. It will get covered by the layered printed square.
6) Cut lengths of ribbon from the 3/8 inch roll of ribbon about 12 inches in length. These strips will be used for the ribbon stripe seen on the cover of the front of the invitation on top of theJapanese paper.
7) Using a hot glue gun, glue each end of the ribbon so it is centered vertically on top of the Japanese band and they meet at the right side of the invitation about 1¾ inches from the right side just like the Japanese Band. Note that the ribbon has a shiny side and a dull side -- the shiny side should face outward!
8) Glue the front printed square on the Front Square Backing provided.
9) Glue this piece about ¾ of an inch from the right side of the invitation covering the ends of the Japanese Band and Ribbon.
|
|
|
