|
|
 |
|
|
|
Sutton
(SKU: INVKT-S0001-SUTTO-2DDCD)
The Sutton design features two fold-out pockets, one on either side of the inner panel. The centered ribbon on both the monogram and inner panel give a strong sense of balance and elegance to the invitation as a whole.
Basic Price (per unit): $3.85 (All prices in U.S. Dollars)
Minimum Order Quantity: 30
|
|
Additional product views:
|
|
|
|
|
 |
What you get in this kit (before customizations) |
 |
- Pocketfolder as shown with pre-assembled inside panel (vertical ribbon stripe main layout) - available in your choice of paper and ribbon colors
- Ribbon: 3/8 inch width in your choice of color
- Printable Paper: 8 ½ x 11 cardstock (2 pieces)
- Front Square backing: 2 ¼ (height) x 3 ¾ (width) inches
- Response card backing: 3 ½ (height) x 4 ½ (width) inches
- Directions card backing: 4 ½ (height) x 4 ½ (width) inches
- Envelope for response card
- Envelope for invitation (unlined)
|
Available Customization Options |
|
Folder Size, Folder Paper, Backing Paper, Printable Paper, Inside Panel, Ribbon Color, Envelope
|
Instructions on this Product |
|
1) Use your favorite computer program to lay out your printed content on two 8 ½ x 11" pages, according to the following sizes:
- Monogram square for cover: 2 (height) x 3 ½ (width) inches
- Invitation main layout: 4 ¾ x 4 ¾ inches
- Response card: 3 ¼ (height) x 4 ¼ (width) inches
- Direction card: 4 ¼ (height) x 4 ¼ (width) inches
(Refer to the sample print template provided in your package for an example.) Remember that sample layouts, wording, and monogram designs are available in the Bride's Guides section of our site.
2) Print and cut the printed parts of your invitations on the 8 ½ x 11 "Printable Paper" sheets provided in the kit.
3) Cut lengths of ribbon from the 5/8 inch roll of ribbon about 5 inches in length. These strips will be used for the ribbon stripe seen on the front square backing.
4) Using a hot glue gun, glue each end of the ribbon (so that the ribbon is running vertically around the backing) so that they meet at the middle of the front square backing centered vertically and horizontally. Note that the ribbon has a shiny side and a dull side -- the shiny side should face outward!
5) Glue the front printed square on the Front Square Backing provided.
6) Glue this piece at the bottom right of the cover of the invitation about ¼ of an inch from the right side and ¼ of an inch from the bottom of the cover.
7) Take the Main Layout you have printed and glue this so it is centered vertically and horizontally on the inside of the pocketfolder on the main panel with the vertical ribbon stripe leaving a 1/8 inch border all around.
8) Glue the Response card you have printed to the Response Card Backing provided.
9) Glue the Directions card you have printed to the Directions Card Backing provided.
|
Print Templates |
|
|
|
|
